![]() ♪ Call Roto-Rooter, that's the name, and away go troubles down the drain. Remember, if you run into trouble, a Roto-Rooter plumber is only a click or call away. Replacing the fill valve and other tank parts may also be necessary to stop a leak. If replacing the flapper doesn't stop the leak, the drain seat itself might be bad or the top surface is corroded and isn't allowing the flapper valve to get a good seal. Once you're satisfied the flapper is not leaking, replace the tank lid and discard the old flapper valve. The flapper valve should form a tight seal that prevents water from escaping the tank and draining into the bowl. It's time to turn-on the water supply again and let the toilet tank re-fill. You may have to adjust the chain a time or two to get it right. ![]() Then push down on the flush lever to make sure the flapper's range of motion is right. Clip the chain to the flush lever, leaving some slack in the chain. Next, line-up your new flapper valve with the pegs on the overflow tube, positioning the flapper over the drain. Wipe off the seal on the valve seat to ensure a good seal. The next step is to pull the flapper from the pivot arm mount pegs on the overflow tube. If tank water is constantly draining into tube, bend arm of float ball down slightly or lower float cup on replacement fill-valve assembly. Disconnect the lift chain from the flush lever. Overflow Tube Illustration by Harry Campbell Prevents tank from overflowing. Next, remove the lid from the tank.then flush the toilet to remove as much water as possible from the tank. To replace a flapper valve, first you need to shut-off your water supply valve behind the toilet. This prevents the flapper from forming a tight seal over the valve seat. A new flapper is soft and flexible but over time, hard water minerals and in-tank cleaning products will damage the rubber causing it to lose its pliability. The flapper valve then slowly lowers over the valve seat to seal off water flow when the flush has completed. A bad flapper valve can also cause a toilet to flush by itself, a condition known as "ghost flushing." A flapper valve is a pliable rubber seal that opens like a lid to allow water into the toilet bowl when the toilet is flushed. The most common reason a toilet leaks is that the flapper valve is worn out or damaged. Can you hear water running in your toilet tank? Do you have to jiggle the flush handle to make it stop? Have you noticed rippling water in the bowl? These are signs that your toilet is leaking water right down the drain.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |